- By:
- Shen, Bo ; Gluesenkamp, Kyle R; Debusk, Melanie M; Li, Zhenning ; Fricke, Brian A
- Page Number:
- 1-8
- Book Title:
- 20th International Refrigeration and Air Conditioning Conference at Purdue
- Publication Date:
- March 12, 2026
- Publisher Location:
- Purdue University, Indiana, United States of America
- Conference Name:
- 20th International Refrigeration and Air Conditioning Conference at Purdue
- Conference Location:
- West Lafayette, Illinois, United States of America
- Conference Sponsor:
- Purdue University
Abstract
A 120 V heat pump water heater (HPWH) is a direct plug-in option to replace gas water heater (WH) without needing expensive electric panel upgrade to 220 V. To enable the smooth transition, the HPWH should provide comparable water heating capacity as the gas WH. WH capacities are rated in the form of first hour rating (FHR). Typical home gas WHs have FHRs > 65 gallon with a 40-gallon water tank. It imposes a major challenge on 120V HPWHs. Most 120V circuits in US can provide 1,800 to 2,400W, not adequate to drive electric resistance heat to boost FHRs. Thus, all the heat needs to come from the heat pump with its top power below 1500 Watts, which is constraint by the installation footprint. This study uses a hardware based, HPWH design model, i.e. the DOE/ORNL Heat Pump Design Model to design a 120V unit with a brazed plate condenser, fin-and-tube evaporator and an adequately sized compressor. To maximize the FHR, multiple strategies were simulated, including use of a mixing valve, overheating the tank temperature to 140F, a new sensing method for quicker response, and an innovative water circulation path. We also simulated 24-hour unform energy factors (UEF) to show the tradeoff between the capacity and operation efficiency. Additionally, we evaluated the impact of insulation thickness on FHR and UEF, to seek further footprint reduction or stretch the tank volume.
