Showing 136 results for Author: Amit Shyam
Sep, 2026
Journal
The use of recycled or scrap or secondary aluminum to manufacture high pressure die castings (HPDC) for structural applications is an opportunity to reduce cost, energy expenditure and emission of greenhouse gases. Technical challenges that must be overcome to achieve this on a large scale include scrap sorting and availability of alloys that can take such feedstock while…
Sep, 2026
Journal
We investigated the high-temperature behavior of binary eutectic nickel-base alloys with low-solubility elements, towards developing alloys with new combinations of structural and functional (e.g. thermal or corrosion) properties. Based on thermodynamic screening, we cast binary near-eutectic Ni-B, Ni-Ca, Ni-Ce, Ni-La, Ni-Y, and Ni-Zr alloys and characterized their microst…
Aug, 2026
Journal
There are no general approaches for predicting the effect of solutes on electrical resistivity changes in aluminum (Al) solid solutions. Here, we introduce a first principles-based approach for predicting temperature-dependent electrical resistivity of Al solid solutions. A combination of electronic structure methods was applied to calculate electronic scattering effects o…
Aug, 2026
Journal
This study investigates the effect of mechanical cold work (0, 50, and 90% cross-sectional area reduction via swaging) on the creep properties of cast aluminum alloys with high electrical conductivity including high-purity Al (HP-Al), Al-0.15Zr (Al-Zr), and Al-0.27Zr-0.08Sn (Al-Zr-Sn, wt%). The Al-Zr alloy is strengthened by Zr in solid solution while the Al-Zr-Sn alloy is…
Aug, 2026
Conference Paper
Oak Ridge National Laboratory (ORNL) has recently launched an effort to economically expand the North American aluminum supply chain by designing and developing a new family of Al-Mg-Si-Fe-Mn structural die cast aluminum alloys that can be made from up to 100% mixed 5xxx and 6xxx series automotive post-consumer sheet scrap and do not require heat treatment. The goal is to…
Aug, 2026
Conference Paper
May, 2026
Journal
It has been recently demonstrated that eutectic alloys processed by additive manufacturing have excellent high-temperature mechanical properties. We suggest that nickel-base eutectic alloys may enable new combinations of structural and functional properties. To this end, we investigate the processability, microstructure, and thermal stability of five, binary near-eutectic…
May, 2026
Journal
As-solidified microstructures of near-eutectic alloys often contain multiple primary phases that are not expected from equilibrium phase diagrams. Such microstructures are caused by cooling-rate-dependent solidification pathways, a factor not captured by the Scheil–Gulliver model or variations thereof. Here, we present a model and algorithm that incorporate the critical nu…
Mar, 2026
Journal
The high cycle fatigue behavior of laser powder bed fusion processed AlSi10Mg has been investigated at 350 °C (T/Tm ∼ 0.7). The alloy exhibited a fatigue strength of 30 MPa defined by runout after 107 cycles at a conventional loading frequency of 20 Hz, corresponding to a notable fatigue strength to ultimate tensile strength ratio of 0.73. The surprising fatigue resistance…
Mar, 2026
Conference Paper
There is a growing trend to die cast structural automotive components from scrap aluminum sources to reduce embodied energy and cost. However, the ability to include most post-consumer scrap is severely limited due to the sensitivities of current industrial high pressure die cast (HPDC) Al alloys to Fe impurities introduced during the recycling process. This study characte…